The Billy Lids

The light will dance on these wintertime snowflakes, made from a variety of crystal-like beads. It’s easy to make a blizzard’s worth of these sparkling Christmas ornaments.

What You Need:

For each snowflake:

• 10 corsage pins with pearl ends (available in fabric and craft stores)
• Crystal-like beads in desired shapes and sizes
• 1 small cork
• Iridescent white glitter paint pen (usually used for fabric, available in craft and discount stores)
• Mono filament thread

Instructions:

1. Add beads to 4 pins. Place beads on 1 corsage pin in desired order, leaving the last 1/4 inch without beads. Make 3 more beaded pins using the same arrangement.

2. Make another set of 4 beaded pins, using a different arrangement. Make an additional set of 2 beaded pins. (You should have a total of 10 beaded pins.)

3. Add 4 matching pins to cork. Cut the cork, if necessary, so it is about 1/4 inch long. With the round side of the cork laying on the work surface, poke one beaded pin into the cork (close to work surface) like a spoke of a wheel. Place a matching beaded pin opposite the first. Place the remaining two opposite each other, between the first set.

4. Add remaining pins. Using the remaining set of 4 matching pins, poke each into the cork, slightly closer to the top of the cork and alternating with the first set of four. Place the remaining 2 beaded pins into each round end of the cork.

5. Cover the cork using glitter paint pen. Allow to dry. Apply a second coat, if necessary, and let dry.

6. To hang, cut a desired length of mono filament and tie to one spoke of the snowflake.